DMTA-10040-01EN, Rev. E, February 2018
Chapter 4108
Return key ( ) is pressed. Subsequently, the TESTS menu reappears on
the instrument display.
○ SD CARD TEST—Checks the internal SD card and external SD card (if
present), and presents a PASSED or FAILED response. To exit the SD
card test, press the Return key ( ). Subsequently, the TESTS menu
reappears on the instrument display.
If an external SD card is not present during the SD card test, FAILED will be
displayed for this storage device.
○ LED TEST—Checks if the instrument LEDs (light-emitting diodes) are
operational. The LEDs are located above the OLYMPUS logo on the
instrument, and are marked with the numbers 1, 2, and 3. During the test,
each individual LED should display a sequence of green, yellow/orange,
and red colors before continuing to the next individual LED color
sequence. If any of these colors are not present, the LED is not working
correctly. To exit the LED test, press the Return key ( ). Subsequently,
the TESTS menu reappears on the instrument display.
The battery or charging indicator LED is not tested during the LED TEST and can
instead be manually inspected. For more information on this LED, see
“Charger/Adaptor” on page 27.
RESET
Provides the ability to reset the instrument as follows:
(1) To access the RESET menu, press the ADV SETUP menu key ( )
followed by the E key, and then rotate the knob to select the desired type
of instrument reset: parameters, storage, or master (see Figure 4-25 on
page 109 and Table 5 on page 109).
(2) To perform the reset, press the A key.
(3) To exit, press the Return key ( ).
To Next Page
Loading...
