Renesas RL78 Series User Manual

RL78/F13, F14 CHAPTER 29 OPTION BYTE
R01UH0368EJ0210 Rev.2.10 1616
Dec 10, 2015
(3) 000C2H/020C2H
 Setting of RESOUTB output function
 Setting of the frequency of the high-speed on-chip oscillator
 Select from 1 MHz, 4 MHz, 8 MHz, 12 MHz, 16 MHz, 24 MHz, 32 MHz, 48 MHz, and 64 MHz.
Caution Set the same value as 000C2H to 020C2H when the boot swap operation is used because 000C2H
is replaced by 020C2H.
29.1.2 On-chip debug option byte (000C3H/ 020C3H)
 Control of on-chip debug operation
 On-chip debug operation is disabled or enabled.
 Control of hot plug-in
 Hot plug-in operation is disabled or enabled.
 Handling of data of flash memory in case of failure in on-chip debug security ID authentication
 Data of flash memory is erased or not erased in case of failure in on-chip debug security ID authentication.
Caution Set the same value as 000C3H to 020C3H when the boot swap operation is used because 000C3H
is replaced by 020C3H.

Renesas RL78 Series Specifications

General

Core	RL78
CPU Clock Speed	Up to 32 MHz
Flash Memory	Up to 512 KB
RAM	Up to 32 KB
Operating Voltage	1.6 V to 5.5 V
Low Power Modes	HALT, STOP, SNOOZE
CPU Architecture	16-bit
Temperature Range	-40°C to +85°C
Package	LQFP
Timers	16-bit timers
Communication Interfaces	UART, I2C, LIN
A/D Converter	12-bit