Renesas RL78 Series User Manual

RL78/F13, F14 CHAPTER 30 FLASH MEMORY
R01UH0368EJ0210 Rev.2.10 1625
Dec 10, 2015
30.1 Serial Programming Using Flash Memory Programmer
The following dedicated flash memory programmer can be used to write data to the internal flash memory of the RL78/F13
and RL78/F14.
 PG-FP5, FL-PR5
 E1 on-chip debugging emulator
Data can be written to the flash memory on-board or off-board, by using a dedicated flash memory programmer.
(1) On-board programming
The contents of the flash memory can be rewritten after the RL78/F13 or RL78/F14 has been mounted on the target
system. The connectors that connect the dedicated flash memory programmer must be mounted on the target system.
(2) Off-board programming
Data can be written to the flash memory with a dedicated program adapter (FA series) before the RL78/F13 or RL78/F14
is mounted on the target system.
Remark FL-PR5 and FA series are products of Naito Densei Machida Mfg. Co., Ltd.

Renesas RL78 Series Specifications

General

Core	RL78
CPU Clock Speed	Up to 32 MHz
Flash Memory	Up to 512 KB
RAM	Up to 32 KB
Operating Voltage	1.6 V to 5.5 V
Low Power Modes	HALT, STOP, SNOOZE
CPU Architecture	16-bit
Temperature Range	-40°C to +85°C
Package	LQFP
Timers	16-bit timers
Communication Interfaces	UART, I2C, LIN
A/D Converter	12-bit