Renesas RL78 Series User Manual

RL78/F13, F14 CHAPTER 30 FLASH MEMORY
R01UH0368EJ0210 Rev.2.10 1626
Dec 10, 2015
Table 30-1. Wiring Between the RL78/F13 or RL78/F14 and Dedicated Flash Memory Programmer
Pin Configuration of Dedicated Flash Memory
Programmer
Pin Name Pin No.
20-pin 30-pin 32-pin 48-pin
Signal Name I/O Pin Function SSOP SSOP
VQFN
(5x5)
LQFP (7x7),
VQFN (7x7)
PG-FP5,
FL-PR5
E1 on-chip
debugging
emulator
 TOOL0 I/O
Transmit/receive
signal
TOOL0/
P40
3 8 3 3
SI/RxD  I/O
Transmit/receive
signal
 RESET Output Reset signal RESET 4 9 4 4
/RESET  Output
VDD I/O
V
DD voltage
generation/
power monitoring
V
DD 10 15 10 12
GND  Ground VSS 9 14 9 11
EVSS    
REGC
Note
8 13 8 10
EMVDD 
Driving power
for TOOL0 pin
VDD 10 15 10 12
EVDD    
Pin Configuration of Dedicated Flash Memory
Programmer
Pin Name Pin No.
64-pin 80-pin 100-pin
Signal Name I/O Pin Function LQFP (10x10) LQFP (12x12) LQFP (14x14)
PG-FP5,
FL-PR5
E1 on-chip
debugging
emulator
 TOOL0 I/O
Transmit/receive
signal
TOOL0/
P40
5 9 12
SI/RxD  I/O
Transmit/receive
signal
 RESET Output Reset signal RESET 6 10 13
/RESET  Output
VDD I/O
V
DD voltage
generation/
power monitoring
V
DD 15 19 22
GND  Ground VSS 13 17 20
EVSS 14 18 21, 43
REGC
Note
12 16 19
EMVDD 
Driving power
for TOOL0 pin
VDD   
EVDD 16 20 23, 53
Note Connect REGC pin to ground via a capacitor (0.47 to 1  F).
Remark Pins that are not indicated in the above table can be left open when using the flash memory programmer
for flash programming.

Renesas RL78 Series Specifications

General

Core	RL78
CPU Clock Speed	Up to 32 MHz
Flash Memory	Up to 512 KB
RAM	Up to 32 KB
Operating Voltage	1.6 V to 5.5 V
Low Power Modes	HALT, STOP, SNOOZE
CPU Architecture	16-bit
Temperature Range	-40°C to +85°C
Package	LQFP
Timers	16-bit timers
Communication Interfaces	UART, I2C, LIN
A/D Converter	12-bit