Ricoh MP C3004 - Tray 1 no Feeding: Late Jam: Cause Code 003

• Reconnect the connector.
• Replace the sensor.
• Replace the Paper Transport IOB.
• Replace the harness.
Target Part/SP No.: Duplex Exit Sensor / SP5-803-010
Cause verification Problem Judgement
Execute an INPUT check when there is no paper at the position of the
referenced sensor.
0: Paper detected
Execute an INPUT check when there is paper at the position of the
referenced sensor.
1: Paper not detected
Solution:
• Clean the sensor.
• Reconnect the connector.
• Replace the sensor.
• Replace the Paper Transport IOB.
• Replace the harness.
Jam
If the error occurs periodically, do the following steps. If the result is as shown in the "Problem
Judgement" column, follow the solutions.
Tray 1 No Feeding: Late Jam : Cause Code 003
Target Part/SP No.:Limit Sensor (1st Feed Tray) / SP5-803-014 (Tray 1: Upper Limit Sensor)
Cause verification Problem Judgement
Execute an INPUT check when there is no paper at the position of the
referenced sensor.
1: Limit
Execute an INPUT check when there is paper at the position of the
referenced sensor.
0: Not limit
Solution:
• Clean the sensor.
Troubleshooting for Transport/Paper Feeding of the Machine
1103