Ricoh MP C3004 - No Paper in Tray 2 Is Displayed Even When the Paper Is in

Feeler for 1st paper end sensor
Cause verification Problem Judgement
Check if the feeler for 1st paper end sensor is unfastened. Feeler is unfastened.
Solution:
• Reinstall the feeler.
• Check if there are any defects in the 1st paper feed unit.
"No paper in Tray 2" is displayed even when the paper is in
Target Part/SP No.:Paper End Sensor (2nd Feed Tray) / SP5-803-019 (Tray 2: Paper End
Detection)
Cause verification Problem Judgement
Execute an INPUT check when there is no paper at the position of
the referenced sensor.
1: Paper detected
Execute an INPUT check when there is paper at the position of the
referenced sensor.
0: Paper not detected
Solution:
• Reconnect the connector.
• Replace the sensor.
• Replace the Paper Transport IOB.
• Replace the harness.
Feeler for 2nd paper end sensor
Cause verification Problem Judgement
Check if the feeler for 2nd paper end sensor is unfastened. Feeler is unfastened.
Solution:
• Reinstall the feeler.
• Check if there are any defects in the 2nd paper feed unit.
Troubleshooting for Transport/Paper Feeding of the Machine
1129