Ricoh MP C3004 - Finisher Jogger Problem (for Booklet Finisher SR3220 (D3 B9); Finisher SR3210 (D3 B8))

If the paper shifts towards the rear
Slide the docking bracket towards the rear by the amount of shift, to move the finisher in the same
direction.
e.g.: When the paper has shifted by 2 mm towards the rear from the center mark (2 mm/division of
the scale), move the docking bracket towards the rear by 2 mm (2 divisions). The divisions move
towards the front.
[A]: Proof Tray
[B]: Docking Bracket Screw
• After the adjustment, check the side-to-side registration by feeding paper out to the proof tray. If the
shift has not been solved, adjust the docking bracket (screw for the docking bracket) slightly again.
Finisher Jogger Problem (For Booklet Finisher SR3220 (D3B9) / Finisher
SR3210 (D3B8))
If a paper alignment problem occurs as shown below, do the following procedure to adjust the jogger
width.
6. Troubleshooting
1142