Service Call 101-195
SC100 (Engine: Scanning)
SC No. Type Error Name/Error Condition/Major Cause/Solution
SC101-01 D LED Error (Scanning)
The white level peak did not reach the prescribed threshold when the
white guide plate was scanned.
• Scanner Carriage defective
• BCU defective
• Connector defective (disconnected, loose)
• Harness defective
• IPU defective
• Condensation in scanner unit
• White Reference Seal dirty or installed incorrectly (sheet-through
exposure glass)
• White Guide Plate, or White Roller dirty or installed incorrectly
(SPDF/ARDF)
6. Troubleshooting
858
To Next Page
Loading...
