4. Press [All PM Parts List : New Unit Set].
5. Set the PM part that you want to replace to "YES" under "New Unit Set".
After pressing "YES", the [Exit] key will not be available.
6. Turn OFF the main power and unplug the power cord from the wall outlet.
7. Replace the PM parts and turn the main power ON.
The machine will reset the PM counters automatically. In the case of the development unit,
developer initialization will also be done automatically.
8. Exit the SP mode.
After installing the new PM parts
1. Output the SMC logging data with SP5-990-004 and check the counter values.
Make sure to shut down and reboot the machine once before printing the SMC. Otherwise, the
latest settings may not be collected when the SMC is printed.
3. Preventive Maintenance
480
To Next Page
Loading...
