Ricoh MP C3004 - Modification for Increasing the LCIT Capacity; List of Parts to be Attached

2. Remove the upper screw at the front side fence, and after setting the side fence to the
position of the paper (outer: A4 LEF, center: LT LEF, inner: B5 LEF), tighten the screw that
was removed.
3. Also change the rear side fence to the same size position.
4. Change the paper size according to the new side fence position.
SP5-181-017 (Size Adjust: LCT)
• 0: A4 LEF
• 1: LT LEF
• 2: B5 LEF
Modification for Increasing the LCIT Capacity
List of Parts to be Attached
You can increase the number of sheets that can be stacked in the LCIT by mounting the following parts.
2. Installation
168