Ricoh MP C3004 - Stapleless Stapler Initial Settings

This can be solved by attaching the proof support tray [B] on the proof tray [A].
Problem that may occur after attaching this support tray:
When using A4, LT or smaller paper, the machine will detect when the tray is full at 200 sheets instead
of the normal 250 sheets.
When using B4, LG or larger paper, the machine detects when the tray is full at 50 sheets as usual.
Stapleless Stapler Initial Settings
• To adjust the strength of the crimp between sheets of stapled paper, there is a setting to select either
single or double stapling.
• The crimp is weakened when there is an image (toner) at the point which is to be stapled. There
also is a setting to mask the image on the point for stapling, in order to prevent the crimp from
being weakened.
• Depending on users demands, explain the settings/methods of the settings by checking the
following instructions.
Finisher SR3210 (D3B8)
279