Ricoh MP C3004 - What Do the LED Indications Mean; Notes for Energy Save Mode Setting; IP Address Setting

What Do the LED Indications Mean?
When this option is properly installed and recognized by the main machine, the LED indicators light up
under the following conditions.
No. Light Color Lights Up When:
1 Green and Yellow 1000BASE-T operates
2 Green 10BASE-T operates
3 Yellow 100BASE-TX operates
Notes for Energy Save Mode Setting
If the machine which has this option enters into the energy save mode, you cannot print because there
will be a communication error. Follow the instructions below to disable the machine’s entering into the
energy save mode.
1. Enter SP mode, and then set SP5-191-001 (Power Setting: Power Str) to "0 (Off)".
IP Address Setting
This section describes how to set an IP address on this option manually. Note that you can set an IP
address which is not only on the same network segment but also on a different network segment to share
a single printer with devices in multiple networks.
• You cannot change the IP address for this option from the operation panel of the main machine.
The setting must be done from a web browser on your PC.
• The network setting of this option is initially assigned as follows:
IP address: 192.168.100.100 / Subnet mask: 255.255.255.0
2. Installation
362
RTB 33: Deleted