1001 [Bit Switch]
1-001-00
5
Bit Switch 5 0 1
bit 0 Show "Collate Type", "Staple Type" and
"Punch Type" buttons on the operation panel.
Disabled Enabled
If enabled, users will be able to configure a Collate Type, Staple Type, and
Punch Type from the operation panel. The available Types will depend on the
device and configured options.
After enabling this BitSw, the settings will appear under:
"User Tools > Printer Features > System"
bit 1 Multiple copies if a paper size or type
mismatch occurs
Disabled
(single
copy)
Enabled
(multiple)
If a paper size or type mismatch occurs during the printing of multiple copies,
only a single copy is output by default. Using this BitSw, the device can be
configured to print all copies even if a paper mismatch occurs.
bit 2 Prevent SDK applications from altering the
contents of a job.
Disabled Enabled
If this BitSw is enabled, SDK applications will not be able to alter print data.
This is achieved by preventing SDK applications from accessing a module
called the "GPS Filter".
Note: The main purpose of this BitSw is for troubleshooting the effects of SDK
applications on data.
bit 3 [PS] PS Criteria Pattern3 Pattern1
Change the number of PS criterion used by the PS interpreter to determine
whether a job is PS data or not.
For details, refer to “page 793 "Printing Features"”.
bit 4
Increase max. number of stored jobs.
Disabled
(100)
Enabled (750)
Changes the maximum number of jobs that can be stored on the HDD. The
default (disabled) is 100. If this is enabled, the max. will be raised to 750 or
1000 depending on the model.
bit 5 DFU - -
4. Controller SP Mode Tables
774
To Next Page
Loading...
