1. Seal [A]
2. Insert a small screwdriver deeply in the bent part of the pin so that the bent tip of the pin is
under the driver, and then release the spring pressure slowly.
• Pull out the screwdriver slowly after the spring pressure is released.
• The spring pressure is extremely strong. For that reason, always use a small screwdriver when
releasing the spring pressure. Never try to release the spring pressure with your finger.
Otherwise, your finger may get caught.
• Do not insert a small screwdriver so that the bent tip of the pin is over the screwdriver. If you
do so, the screwdriver slips off the pin when releasing the spring pressure and then it may
damage parts inside the unit.
4. Replacement and Adjustment
548
To Next Page
Loading...
