• The NVRAM data download may fail if the SD card with the NVRAM data is damaged, or if the
connection between the controller and BCU is defective.
• Do the download procedure again if the download fails.
• Do the following procedure if the second attempt fails:
• Enter the NVRAM data manually using the SMC print you created before uploading the NVRAM
data.
1. Turn OFF the main power.
2. Remove the SD slot cover.
3. Insert the SD card with the NVRAM data into SD Card Slot 2 (lower).
4. Switch ON the main power.
5. Do SP5-825-001 (NVRAM Data Download) and press the "Execute" key.
• The serial number of the file on the SD card must match the serial number of the machine for
the NVRAM data to download successfully. The download fails if the serial numbers do not
match.
This procedure does not download the following data to the NVRAM:
• Total Count
• C/O, P/O Count
5. System Maintenance
804
To Next Page
Loading...
