Rohde & Schwarz MXO 4 Series - Page 126

Acquisition and waveform setupMXO 4 Series
126User Manual 1335.5337.02 ─ 07
An external attenuation can be set on the "Other" tab, see Chapter 6.3.5, "Other verti-
cal settings", on page 123.
The common probe settings are:
Predefined probe, name and type of the probe...........................................................126
Probe bandwidth......................................................................................................... 127
Offset...........................................................................................................................127
Vertical unit..................................................................................................................127
Attenuation.................................................................................................................. 127
Set offset to mean....................................................................................................... 127
AutoZero, Use AutoZero............................................................................................. 128
Predefined probe, name and type of the probe
The model name and type of a detected probe are shown in the dialog.
If the instrument cannot recognize the probe, "None" is indicated in the "Predefined
probe" list. Select the used probe on the list. The corresponding bandwidth, and
attenuation or gain are shown.
If the probe is not detected and not listed as predefined probe, it is an unknown probe.
To configure these probes, set "Predefined probe" to "User-Defined". Then adjust the
Vertical unit and Attenuation.
Remote command:
PROBe<ch>:SETup:NAME? on page 524
PROBe<ch>:SETup:TYPE? on page 525
Probes