ApplicationsMXO 4 Series
260User Manual 1335.5337.02 ─ 07
Input
Sets the channel for the input signal of the DUT.
Remote command:
FRANalysis:INPut[:SOURce] on page 663
Output
Sets the channel for the output signal of the DUT.
Remote command:
FRANalysis:OUTPut[:SOURce] on page 664
Generator
Selects the built-in generator to start a frequency sweep for a defined frequency range.
Remote command:
FRANalysis:GENerator[:CHANnel] on page 663
Start, Stop
Set the start and stop frequency of the sweep.
Frequency response analysis (option R&S
MXO4-K36)
To Next Page
Loading...
