Getting StartedMXO 4 Series
43User Manual 1335.5337.02 ─ 07
[Position]
The vertical [Position] knob changes the vertical offset or the position of the selected
waveform. The horizontal axis and the selected waveform are moved vertically. You
can select whether the knob changes the offset or the position in the "Menu" > "Set-
tings" > "Frontpanel" > "Knobs" dialog.
●
Position indicates the vertical location in divisions.
●
Offset moves the vertical center of the selected channel to the offset value.
If the selected waveform is a math or reference waveform, serial bus, or logic channel,
the knob changes its vertical position.
The knob lights up in the color of the selected waveform. Turn clockwise to move up
the waveform. To set the value to zero, press the knob.
The current offset value is shown in the channel icon.
Remote command:
CHANnel<ch>:POSition on page 510
CHANnel<ch>:OFFSet on page 510
[Scale]
Sets the vertical scale, which defines the displayed amplitude of the selected wave-
form.
The [Scale] knob lights up in the color of the selected waveform.
Turn the knob clockwise to stretch the waveform. Doing so, the scale value V/div
decreases. Press the knob to toggle between fine and coarse adjustment. For analog
waveforms, the scale value is shown in the signal icon.
To get the maximum resolution of the waveform amplitude, make sure that the wave-
forms cover most of the diagram's height.
Remote command:
CHANnel<ch>:SCALe on page 509
CALCulate:MATH<m>:VERTical:SCALe[:VALue] on page 584
REFCurve<rc>:SCALe on page 593
[Gen]
Opens the "Waveform Generator" dialog, if option R&S MXO4-B6 is installed.
The waveform generator can generate various function and arbitrary waveforms,
sweeps, and parallel patterns. For detailed characteristics, refer to the specifications
document.
[Logic]
Opens the "Logic" dialog to configure and enable the logic buses L1 to L4. A logic bus
(or parallel bus) has up to 16 logic (digital) channels. If logic buses are active, pressing
the key toggles these buses.
The key lights up if at least one logic bus is enabled.
[Ref]
Opens the "Reference" dialog box, where you can configure and display reference
waveforms. Press the key repeatedly to switch the reference waveform.
Instrument tour
To Next Page
Loading...
