Rohde & Schwarz MXO 4 Series - Page 488

Remote control commandsMXO 4 Series
488User Manual 1335.5337.02 ─ 07
LAYout<ly>:COUNt?.......................................................................................................488
LAYout<ly>[:ENABle]......................................................................................................488
LAYout<ly>:ACTive.........................................................................................................488
LAYout<ly>:SACTive...................................................................................................... 489
LAYout<ly>:LABel.......................................................................................................... 489
LAYout<ly>:DIAGram<da>:COUNt?................................................................................. 489
LAYout<ly>:DIAGram<da>[:ENABle]................................................................................ 489
LAYout<ly>:DIAGram<da>:SOURce.................................................................................490
LAYout<ly>:DIAGram<da>:LABel.....................................................................................490
LAYout<ly>:NODE<no>:COUNt?..................................................................................... 490
LAYout<ly>:NODE<no>[:ENABle].................................................................................... 491
LAYout<ly>:NODE<no>:CHILdren<o>:CONTent<p>:ID...................................................... 491
LAYout<ly>:NODE<no>:CHILdren<o>:CONTent<p>:TYPE.................................................491
LAYout<ly>:NODE<no>:RATio.........................................................................................492
LAYout<ly>:NODE<no>:STYPe....................................................................................... 492
LAYout<ly>:COUNt?
Returns the number of available layouts, i.e. SmartGrid configurations. By default, they
named "Diagram Set" on the display.
Suffix:
<ly>
.
Irrelevant, omit the suffix.
Return values:
<Count> Number of SmartGrid configurations
Usage: Query only
Asynchronous command
LAYout<ly>[:ENABle] <State>
Creates a new SmartGrid configuration and sets it active.
Suffix:
<ly>
.
1...4, index of the SmartGrid layout
Parameters:
<State> ON | OFF
Example: See Chapter 17.4.1, "SmartGrid layout with zoom", on page 474.
Usage: Asynchronous command
LAYout<ly>:ACTive <ActiveKey>
Sets the active SmartGrid configuration. The query returns the index of the active lay-
out.
Suffix:
<ly>
.
Irrelevant, omit the suffix.
Instrument setup