Rohde & Schwarz MXO 4 Series - Page 490

Remote control commandsMXO 4 Series
490User Manual 1335.5337.02 ─ 07
<da> 1...8, index of the diagram
Parameters:
<State> ON | OFF
Example: See Chapter 17.4.1, "SmartGrid layout with zoom", on page 474.
Usage: Asynchronous command
LAYout<ly>:DIAGram<da>:SOURce <SignalKeys>
Assigns the waveforms to a diagram.
Suffix:
<ly>
.
1...4, index of the SmartGrid layout
<da> 1...8, index of the diagram
Parameters:
<SignalKeys> String with a comma-separated list of waveforms, e.g. "C1,
C2, M1"
Example: See Chapter 17.4.1, "SmartGrid layout with zoom", on page 474.
Usage: Asynchronous command
LAYout<ly>:DIAGram<da>:LABel <Label>
Defines a name for the specified diagram in a specified layout.
Suffix:
<ly>
.
1...4, index of the SmartGrid layout
<da> 1...8, index of the diagram
Parameters:
<Label> String with the diagram name
Usage: Asynchronous command
LAYout<ly>:NODE<no>:COUNt?
Returns the maximum number of nodes that can be defined. This number is the maxi-
mum value for the node suffix.
Suffix:
<ly>
.
1...4, index of the SmartGrid layout
<no> Irrelevant, omit the suffix.
Return values:
<Count> Maximum value for the node suffix
Usage: Query only
Asynchronous command
Instrument setup