Rohde & Schwarz MXO 4 Series - Page 625

Remote control commandsMXO 4 Series
625User Manual 1335.5337.02 ─ 07
Manual operation: See "Coupling mode" on page 222
GATE<g>:CURSor <Cursorset>
Available for GATE<g>:GCOupling = CURSor.
Selects the cursor set to be used for measurement gating. The gate area is defined by
the cursor lines.
Suffix:
<g>
.
1...2, index of the gate
Parameters:
<Cursorset> CURSOR1 | CURSor1 | CURSOR2 | CURSor2
CURSORx = CURSorx
*RST: CURSOR1
Usage: Asynchronous command
Manual operation: See "Coupling mode" on page 222
GATE<g>:ZDIagram <SignalSource>,[<SignalSource2>]
GATE<g>:ZDIagram? <SignalSource>
Available for GATE<g>:GCOupling = ZOOM.
The gate area is defined identically to the zoom area for the selected zoom diagram.
Suffix:
<g>
.
1...2, index of the gate
Parameters:
<SignalSource2>
Parameters for setting and query:
<SignalSource>
Usage: Asynchronous command
Manual operation: See "Coupling mode" on page 222
GATE<g>:MODE <Mode>
Selects if the gate settings are configured using absolute or relative values.
Suffix:
<g>
.
1...2, index of the gate
Parameters:
<Mode> ABS | REL
*RST: ABS
Usage: Asynchronous command
Manual operation: See "Mode" on page 222
Automatic measurements