Rohde & Schwarz MXO 4 Series - Page 626

Remote control commandsMXO 4 Series
626User Manual 1335.5337.02 ─ 07
GATE<g>:ABSolute:STARt <Start>
GATE<g>:ABSolute:STOP <Stop>
Define the absolute start and end values for the gate, respectively.
Available, if GATE<g>:GCOupling = MANUal and GATE<g>:MODE =ABS.
Suffix:
<g>
.
1...2, index of the gate
Parameters:
<Stop> Range: -1E+26 to 1E+26
Increment: 0.01
*RST: 0.01
Default unit: Depends on the underlying waveform
Usage: Asynchronous command
Manual operation: See "Mode" on page 222
GATE<g>:RELative:STARt
<RelativeStart>
GATE<g>:RELative:STOP <RelativeStop>
Define the relative start and end values for the gate, respectively.
Available, if GATE<g>:GCOupling = MANUal and GATE<g>:MODE =REL.
Suffix:
<g>
.
1...2, index of the gate
Parameters:
<RelativeStop> Range: 0 to 100
Increment: 0.1
*RST: 100
Default unit: %
Usage: Asynchronous command
Manual operation: See "Mode" on page 222
GATE<g>:SHOW <DisplayState>
If enabled, the gate area is indicated in the source diagram.
Suffix:
<g>
.
1...2, index of the gate
Parameters:
<DisplayState> ON | OFF
*RST: ON
Usage: Asynchronous command
Automatic measurements