Rohde & Schwarz MXO 4 Series - Page 747

Remote control commandsMXO 4 Series
747User Manual 1335.5337.02 ─ 07
SBUS<sb>:UART:TX:SOURce........................................................................................ 751
SBUS<sb>:UART:TX:THReshold.....................................................................................751
SBUS<sb>:UART:RX:POSition........................................................................................751
SBUS<sb>:UART:RX:SCALe.......................................................................................... 752
SBUS<sb>:UART:TX:POSition........................................................................................ 752
SBUS<sb>:UART:TX:SCALe...........................................................................................752
SBUS<sb>:UART:BITRate <Bitrate>
Sets the number of transmitted bits per second.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Bitrate> Range: 300 to 20000000
Increment: 1
*RST: 9600
Default unit: bps
Usage: Asynchronous command
Manual operation: See "Bit rate" on page 357
SBUS<sb>:UART:BORDer <BitOrder>
Selects the bit order, which determines if the data of the messages starts with MSB
(most significant bit) or LSB (least significant bit).
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<BitOrder> LSBF | MSBF
*RST: LSBF
Usage: Asynchronous command
Manual operation: See "Bit order" on page 357
SBUS<m>:UART:EWORd <EndWord>
Sets the end pattern of the packets. A new packet starts with the first start bit after the
defined end pattern.
The command is relevant if SBUS<sb>:UART:PACKets is set to EWORd.
Suffix:
<m>
.
1...4, index of the serial bus
Parameters:
<EndWord>
Usage: Asynchronous command
Protocols