Rohde & Schwarz MXO 4 Series - Page 751

Remote control commandsMXO 4 Series
751User Manual 1335.5337.02 ─ 07
Usage: Asynchronous command
Manual operation: See "Packets" on page 357
SBUS<sb>:UART:TX:HYSTeresis <Tx hysteresis>
Sets the hysteresis for the TX line.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Tx hysteresis>
Usage: Asynchronous command
Manual operation: See "Threshold" on page 358
SBUS<sb>:UART:TX:SOURce TXSource
Selects the input channel for the transmitter signal.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
TXSource C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9
| D10 | D11 | D12 | D13 | D14 | D15 | M1 | M2 | M3 | M4 | M5 |
R1 | R2 | R3 | R4
Usage: Asynchronous command
Manual operation: See "Source: Tx, Rx" on page 356
SBUS<sb>:UART:TX:THReshold <Tx threshold>
Sets a user-defined threshold value for the Tx line.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Tx threshold> User-defined clock threshold
Usage: Asynchronous command
Manual operation: See "Threshold" on page 358
SBUS<sb>:UART:RX:POSition <Rx position>
Sets the vertical position of the RX UART signal.
Suffix:
<sb>
.
1...4, index of the serial bus
Protocols