Rohde & Schwarz MXO 4 Series - Page 750

Remote control commandsMXO 4 Series
750User Manual 1335.5337.02 ─ 07
Parameters:
<Rx threshold>
Usage: Asynchronous command
Manual operation: See "Threshold" on page 358
SBUS<sb>:UART:SBIT <StopBits>
Sets the number of stop bits: 1 or 1.5 or 2 stop bits are possible.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<StopBits> B1 | B15 | B2
*RST: B1
Usage: Asynchronous command
Manual operation: See "Stop bits" on page 357
SBUS<sb>:UART:SSIZe <DataBits>
Sets the number of data bits of a word in a range from 5 bits to 8 bits. If no parity bit is
used, then 9 data bits are possible.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<DataBits> Range: 5 to 9
Increment: 1
*RST: 8
Usage: Asynchronous command
Manual operation: See "Data bits" on page 357
SBUS<sb>:UART:TOUT <Timeout>
Sets the timeout between packets in a UART data stream. A new packet starts with the
first start bit after the timeout.
The command is relevant if SBUS<sb>:UART:PACKets is set to TOUT.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Timeout> Range: 1E-06 to 1
Increment: 1
*RST: 0.000625
Default unit: s
Protocols