Protocol analysisMXO 4 Series
358User Manual 1335.5337.02 ─ 07
"End word"
Defines a pattern as end condition of a packet, for example, a
reserved word like CR or LF. The bit pattern editor provides frequently
used values in the "Predefined values" list below the pattern table.
A new packet starts with the first start bit after the defined end pat-
tern.
"Timeout"
Defines a timeout between a stop bit and the next start bit. Enter the
minimum time that marks the end of a packet.
A new packet starts with the first start bit after the timeout.
Remote command:
SBUS<sb>:UART:PACKets on page 748
SBUS<sb>:UART:TOUT on page 750
SBUS<m>:UART:EWORd on page 747
13.4.2.2 Threshold settings
Access: [Apps] key > "Protocol" tab > "UART / RS232" > "Thresholds".
Threshold
Sets the threshold for the Tx and Rx channels. Enter the value directly in the fields.
Additional to the threshold, you can also set a hysteresis.
Remote command:
SBUS<sb>:UART:RX:HYSTeresis on page 749
SBUS<sb>:UART:RX:THReshold on page 749
UART (option R&S
MXO4-K510)
To Next Page
Loading...
