Rohde & Schwarz MXO 4 Series - Page 752

Remote control commandsMXO 4 Series
752User Manual 1335.5337.02 ─ 07
Parameters:
<Rx position>
Usage: Asynchronous command
SBUS<sb>:UART:RX:SCALe <Rx scale>
Set the vertical scale of the RX UART signal.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Rx scale>
Usage: Asynchronous command
SBUS<sb>:UART:TX:POSition <Tx position>
Sets the vertical position of the TX UART signal.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Tx position>
Usage: Asynchronous command
SBUS<sb>:UART:TX:SCALe <Tx scale>
Set the vertical scale of the TX UART signal.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Tx scale>
Usage: Asynchronous command
17.16.4.2 Trigger
Trigger commands for serial buses affect the current trigger source. Therefore, set the
trigger source to the required serial bus with TRIGger:EVENt<ev>:SOURce before
sending the bus-specific trigger commands.
TRIGger:UART:DATA..................................................................................................... 753
TRIGger:UART:DPOSition...............................................................................................753
TRIGger:UART:FCONdition.............................................................................................753
TRIGger:UART:OPERator...............................................................................................753
TRIGger:UART:SOURce.................................................................................................753
TRIGger:UART:TYPE..................................................................................................... 754
Protocols