Rohde & Schwarz MXO 4 Series - Page 764

Remote control commandsMXO 4 Series
764User Manual 1335.5337.02 ─ 07
SBUS<sb>:CAN:SOURce Source
Sets the source channel to which the line is connected.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
Source C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9
| D10 | D11 | D12 | D13 | D14 | D15 | M1 | M2 | M3 | M4 | M5 |
R1 | R2 | R3 | R4
Usage: Asynchronous command
Manual operation: See "Data" on page 370
SBUS<sb>:CAN:FDATa:DBITrate <FDBitrate>
Sets the bit rate of the data phase.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<FDBitrate> Range: 10000 to 15000000
Increment: 100
*RST: 1000000
Default unit: bps
Usage: Asynchronous command
Manual operation: See "FD bit rate" on page 371
SBUS<sb>:CAN:FDATa:SAMPlepoint <FDSamplePoint>
Sets the position of the sample point within the bit in percent of the nominal bit time.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<FDSamplePoint> Range: 30 to 90
Increment: 5
*RST: 66
Default unit: %
Usage: Asynchronous command
Manual operation: See "FD sample point" on page 371
SBUS<sb>:CAN:SIC:HYSTeresis <Hysteresis>
Sets a hysteresis value for the SIC transceiver mode.
Protocols