Rohde & Schwarz MXO 4 Series - Page 763

Remote control commandsMXO 4 Series
763User Manual 1335.5337.02 ─ 07
SBUS<sb>:CAN:NEWList...............................................................................................767
SBUS<sb>:CAN:POSition...............................................................................................767
SBUS<sb>:CAN:SCALe................................................................................................. 767
SBUS<sb>:CAN:TYPE <SignalType>
Selects the CAN-High or CAN-Low line. Both lines are required for differential signal
transmission used by CAN.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<SignalType> CANL | CANH
*RST: CANL
Usage: Asynchronous command
Manual operation: See "Type" on page 370
SBUS<sb>:CAN:BITRate
<Bitrate>
Sets the number of transmitted bits per second.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Bitrate> Range: 10000 to 5000000
Increment: 100
*RST: 100000
Default unit: bps
Usage: Asynchronous command
Manual operation: See "Nominal bit rate" on page 370
SBUS<sb>:CAN:SAMPlepoint <SamplePoint>
Sets the position of the sample point within the bit in percent of the nominal bit time.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<SamplePoint> Range: 30 to 90
Increment: 5
*RST: 66
Default unit: %
Usage: Asynchronous command
Manual operation: See "Sample point" on page 370
Protocols