Rohde & Schwarz MXO 4 Series - Page 767

Remote control commandsMXO 4 Series
767User Manual 1335.5337.02 ─ 07
Parameters:
<ShowSymbols> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Show symbols" on page 373
SBUS<sb>:CAN:NEWList <FileName>
Loads a symbol list file.
Suffix:
<sb>
.
1...4, index of the serial bus
Setting parameters:
<FileName> String parameter with path and file name.
Example:
SBUS1:CAN:NEWList
'/home/storage/userData/Protocol/CAN.csv'
SBUS1:CAN:SYMBols ON
Usage: Setting only
Asynchronous command
Manual operation: See "Show symbols" on page 373
SBUS<sb>:CAN:POSition <CAN position>
Sets the vertical position of the CAN signal.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<CAN position>
Usage: Asynchronous command
SBUS<sb>:CAN:SCALe <CAN scale>
Set the vertical scale of the indicated CAN signal.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<CAN scale>
Usage: Asynchronous command
Protocols