Rohde & Schwarz MXO 4 Series - Page 871

Remote control commandsMXO 4 Series
871User Manual 1335.5337.02 ─ 07
WGENerator<wg>:ARBGen:NAME <Folder>
Sets the file path and the file for an arbitrary waveform, if WGENerator<wg>:
ARBGen[:SOURce] is set to ARBitrary.
Suffix:
<wg>
.
1...2, index of the waveform generator
Parameters:
<Folder>
Usage: Asynchronous command
Manual operation: See "Open" on page 445
WGENerator<wg>:ARBGen:OPEN
Loads the arbitrary waveform, which is selected with the WGENerator<wg>:ARBGen:
NAME command.
Suffix:
<wg>
.
1...2, index of the waveform generator
Usage: Event
Asynchronous command
Manual operation: See "Open" on page 445
WGENerator<wg>:ARBGen:RUNMode <RunMode>
Sets the duration for which the signal of the arbitrary generator will be output after the
trigger event.
Suffix:
<wg>
.
1...2, index of the waveform generator
Parameters:
<RunMode> SINGle | REPetitive
*RST: REPetitive
Usage: Asynchronous command
Manual operation: See "Run mode" on page 444
WGENerator<wg>:ARBGen:RUNSingle
Executes a single period of the arbitrary signal generator, if WGENerator<wg>:
ARBGen:RUNMode is set to SINGle.
Suffix:
<wg>
.
1...2, index of the waveform generator
Usage: Event
Asynchronous command
Waveform generator (option R&S MXO4-B6)