Rohde & Schwarz RTE Series - Page 122

Getting started
R&S
®
RTE
122User Manual 1326.1032.02 ─ 20
Masktest
Starts the on-screen mask definition and the testing against the defined mask.
Tap the icon and then tap the points that build the mask. Double-tap the last point to
finish mask definition. To create a rectangular mask, draw a rectangle on the screen.
You can move the mask on the screen.
To configure the mask test settings, tap the
icon in the "Mask" result box.
Histogram
The histogram icon on the toolbar shows the last selected histogram type. A short tap
on the icon activates the selected histogram.
If you touch the icon and drag your finger down, a menu opens where you can select
another histogram type: horizontal histogram, or vertical histogram.
Tap the icon and then drag a rectangle on the diagram to mark the histogram area. The
histogram for the selected waveform appears.
Touch and hold the histogram area to open the "Histogram" dialog box.
Measurement
Starts an automatic measurement.
You can run up to 8 automatic measurements in parallel. The "Automatic measurment"
icon starts the measurements one after the other.
Tap the icon and then tap the diagram with the waveform to be measured. To define a
measurement gate, draw a rectangle on the screen.
To modify the measurement, tap the icon in the "Measurement" result box.
Quick meas
Performs a set of measurements on the selected waveform. You can configure up to 8
measurement type to be included in quick measurement.
Tap the icon and then tap the diagram with the waveform to be measured.
FFT
Transforms a waveform to the frequency spectrum by fast Fourier transform (FFT). The
FFT trace is shown in a new diagram.
Tap the icon and then tap diagram with the waveform to be transformed. The FFT dia-
gram is created from the selected waveform.
To adjust FFT settings, double-tap the FFT diagram.
Select
Enables the select mode to move and modify objects on the touchscreen. The select
mode is activated automatically when an analyzing function is completed.
Delete
Removes zoom and histogram areas and their diagrams; measurement areas and their
associated results; and mask segments. The icon also switches off a waveform.
Tap the icon and then tap the area or diagram to be deleted, or the waveform to be
switched off.
Operating the instrument