Rohde & Schwarz RTE Series - Page 1482

Remote control commands
R&S
®
RTE
1482User Manual 1326.1032.02 ─ 20
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Packets> NONE | EWORd | TOUT
NONE
Packets are not considered.
EWORd
End word, the end condition of a packet is a pattern. To define
the end word, use BUS<m>:UART:EWORd
TOUT
Defines a timeout between the packets. To set the timeout, use
BUS<m>:UART:TOUT
*RST: NONE
Firmware/software: FW 2.25
BUS<m>:UART:TOUT <InterframeTime>
Sets the timeout between packets in a UART data stream. A new packet starts with the
first start bit after the timeout.
The command is relevant if BUS<m>:UART:PACKets is set to TOUT.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<InterframeTime> Range: 1E-6 to 1
Increment: 1
*RST: 1E-3
Default unit: s
Usage: Asynchronous command
Firmware/software: FW 2.25
BUS<m>:UART:EWORd <EndOfFrame>
Sets the end pattern of the packets. A new packet starts with the first start bit after the
defined end pattern.
The command is relevant if BUS<m>:UART:PACKets is set to EWORd.
Suffix:
<m>
.
1..4
Selects the serial bus.
Protocols