Rohde & Schwarz RTE Series - Page 1904

Remote control commands
R&S
®
RTE
1904User Manual 1326.1032.02 ─ 20
BUS<m>:PARallel:CLSLope..........................................................................................1909
BUS<m>:PARallel:CLEar..............................................................................................1909
BUS<m>:PARallel:DECTable<n>:SHOW........................................................................1910
BUS<m>:PARallel:DECTable<n>:COUNt?......................................................................1910
BUS<m>:PARallel:DECTable<n>:DATA?........................................................................ 1910
BUS<m>:PARallel:STATe <Enable>
Enables or disables the indicated parallel bus. The threshold settings of the bus take
effect for all active parallel buses.
Dependencies: At least one digital channel must be enabled for the selected bus, oth-
erwise the command does not work. The bus is enabled automatically if the first digital
channel is enabled with BUS<m>:PARallel:BIT<n>[:STATe] or DIGital<m>:
DISPlay.
Suffix:
<m>
.
1..4
Selects the parallel bus.
Parameters:
<Enable> ON | OFF
*RST: OFF
BUS<m>:PARallel:BIT<n>[:STATe] <Assigned>
Assigns the selected digital channel to the indicated bus, displays it, and enables the
bus if the bus was disabled. That is, BUS<m>:PARallel:DISPlay:SHDI and
BUS<m>:PARallel:STATe are set to ON automatically.
If another active bus already uses the selected digital channel, the instrument disables
the other bus to avoid conflicts.
For parallel bus 1, the BUS:PAR:BIT[:STATe] command has the same effect as
DIGital<m>:DISPlay.
Suffix:
<m>
.
1..4
Selects the parallel bus.
<n> 0..15
Selects the bit of the bus word. Each bit corresponds to a digital
channel.
Parameters:
<Assigned> ON | OFF
*RST: OFF
BUS<m>:PARallel:THReshold<n> <Threshold>
Sets the logical threshold for the indicated channel group.
Mixed signal option (MSO, R&S
RTE-B1)