Rohde & Schwarz RTE Series - Page 528

Protocol analysis
R&S
®
RTE
528User Manual 1326.1032.02 ─ 20
No Ack (Missing Ack) ← Trigger type
Missing acknowledge bit: the instrument triggers if the data line remains HIGH during
the clock pulse following a transmitted byte.
You can also localize specific missing acknowledge bits by setting the No Ack condi-
tions.
Address ← Trigger type
Sets the trigger to one specific address condition or a combination of address condi-
tions. The trigger time is the falling clock edge of the acknowledge bit after the
address. You can specify:
●
Adress Type
●
"Address" on page 530
●
R/W bit
Address OR ← Trigger type
Triggers on one to four address conditions. Each enabled condition requires an exact
address. You can specify:
For each condition to be used, select "Monitor"
●
"Monitor" on page 530
●
Adress Type
●
"Address" on page 530
●
R/W bit
I²C (option R&S
RTE-K1)