Rohde & Schwarz RTE Series - Page 682

Protocol analysis
R&S
®
RTE
682User Manual 1326.1032.02 ─ 20
Make sure that:
●
In the [PROTOCOL] > "Decode" tab:
– The correct "Protocol" is selected.
– The data sources of the serial bus are channel signals.
●
In the "Trigger" > "Setup" tab:
– The trigger "Sequence" = "A only".
– The trigger "Source" = "Serial bus".
– The correct "Serial bus" is selected.
Trigger Type
Selects the trigger type for ARINC 429 analysis.
"Word Start"
Sets the trigger to the start of the word.
"Word Stop"
Sets the trigger to the stop of the word.
"Label + Data"
Sets the trigger on a defined word format. You can define the label,
the data and the SDI / SSM bits separately, see "Label + Data"
on page 683.
"Error Condition"
Identifies various errors in the word, see "Error Conditions"
on page 684.
Remote command:
TRIGger<m>:ARINc:TYPE on page 1636
ARINC 429 (option R&S
RTE-K7)