Rohde & Schwarz RTE Series - Page 844

Protocol analysis
R&S
®
RTE
844User Manual 1326.1032.02 ─ 20
"Glitch Error"
Searches for glitch errors (errors in the bit period, see USB standard
for the definition of glitch).
Remote command:
SEARch:TRIGger:USB:GLITcherror on page 1817
Address check
Enables the search for an address that meets specific conditions.
"Condition"
Defining a specific address or an address range requires to set the
operator to one of the following: equal, not equal, less than, less than
or equal, greater than, greater than or equal, in range, out of range.
"Min"
Specifies an address, or sets the start value of an address range.
"Max"
Sets the end value of an address range if "Condition" (SEARch:
TRIGger:USB:ACONdition) is set to INRange or OORange.
Remote command:
SEARch:TRIGger:USB:WADD on page 1824
SEARch:TRIGger:USB:ACONdition on page 1812
SEARch:TRIGger:USB:AMIN on page 1813
SEARch:TRIGger:USB:AMAX on page 1813
End Point check
Enables the search for an endpoint that meets specific conditions.
"Condition"
Defining a specific endpoint or an endpoint range requires to set the
operator to one of the following: equal, not equal, less than, less than
or equal, greater than, greater than or equal, in range, out of range.
"Min"
Specifies an endpoint, or sets the start value of an endpoint range.
"Max"
Sets the end value of an endpoint range if "Condition" (SEARch:
TRIGger:USB:ECONdition) is set to INRange or OORange.
Remote command:
SEARch:TRIGger:USB:WEND on page 1824
SEARch:TRIGger:USB:ECONdition on page 1815
SEARch:TRIGger:USB:EMIN on page 1816
SEARch:TRIGger:USB:EMAX on page 1816
Frame number check
Enables the search for a frame number that meets specific conditions.
"Condition"
Defining a specific frame number or a frame number range requires
to set the operator to one of the following: equal, not equal, less than,
less than or equal, greater than, greater than or equal, in range, out
of range.
"Min"
Specifies a frame number, or sets the start value of a frame number
range.
"Max"
Sets the end value of a frame number range if "Condition" (SEARch:
TRIGger:USB:FCONdition) is set to INRange or OORange.
USB (option R&S RTE-K60)