Rohde & Schwarz RTE Series - Page 902

Mixed signal option (MSO, R&S RTE-B1)
R&S
®
RTE
902User Manual 1326.1032.02 ─ 20
See also: "Bus representation" on page 901
Data format
Sets the data format of bus values, which are displayed in the decode table and on the
comb bus display. Available formats are: Hex, ASCII, octal, binary, signed, and
unsigned.
Signed and Unsigned are integer data types with maximum 16-bit length. Unsigned is
used for positive integers. Signed is used for positive and negative integers.
If the target file format is BIN, you can save only signed and unsigned binary data. The
data format "Signed" writes signed data; all other formats are saved as unsigned
binary data.
Remote command:
BUS<m>:PARallel:DATA:FORMat on page 1907
Clocked bus setup
If a bus is a clocked bus, one of the digital channels serves as clock of the bus.
For an unclocked bus, the logical state of the bus is determined for each sample. For a
clocked bus, the logical state is determined only at the specified clock edges.
The settings are only available for "Bus1" and "Bus2".
"Enable
clocked bus"
Enable this option, if the bus is a clocked bus.
"Show decode
table"
The decode table is only available for clocked buses to check the
data words. If enabled, a results box opens with decoded values of
the bus signal and its time. Each clock edge corresponds to one row
in the table.
"Clock source"
Selects the digital channel used as clock.
"Clock slope"
Selects the slope of the clock signal at which all digital channels of
the bus are analyzed.
Remote command:
BUS<m>:PARallel:CLON on page 1909
BUS<m>:PARallel:CLOCk on page 1909
BUS<m>:PARallel:CLSLope on page 1909
BUS<m>:PARallel:DECTable<n>:SHOW on page 1910
Digital channels and parallel buses