Mixed signal option (MSO, R&S RTE-B1)
R&S
®
RTE
901User Manual 1326.1032.02 ─ 20
Show dig. signals
If enabled, the selected digital channels are shown in the diagram. Each channel is dis-
played as a logic signal.
Remote command:
BUS<m>:PARallel:DISPlay:SHDI on page 1908
Show bus
If enabled, the resulting bus signal and bus values are displayed in the diagram. Select
the presentation type for the bus signal with "Bus representation" on page 901.
Remote command:
BUS<m>:PARallel:DISPlay:SHBU on page 1908
Bus representation
Defines how the parallel bus is displayed.
"Comb"
Displays the decoded bus signal with bus values. When at least one
digital channel changes its value, the bus value changes too.
"Analog"
Displays the bus values as signal amplitudes, similar to an analog
waveform. Thus, a quasi-analog waveform is created.
Remote command:
BUS<m>:PARallel:DISPlay:BTYP on page 1908
Amplitude Range
If the bus representation is "Analog", the amplitude range defines the voltage range for
the display of the analog bus. The highest bus value corresponds to the "Maximum
voltage", and the lowest bus value to the "Minimum voltage".
Digital channels and parallel buses
To Next Page
Loading...
