Rohde & Schwarz RTE Series - Page 900

Mixed signal option (MSO, R&S RTE-B1)
R&S
®
RTE
900User Manual 1326.1032.02 ─ 20
If you have configured several parallel buses and you want to modify the settings,
make sure that the tab of the correct bus is selected on the left side, and disable the
bus before you change the settings.
Enable bus.................................................................................................................. 900
Show dig. signals........................................................................................................ 901
Show bus.................................................................................................................... 901
Bus representation......................................................................................................901
Amplitude Range.........................................................................................................901
Data format................................................................................................................. 902
Clocked bus setup.......................................................................................................902
Signal selection...........................................................................................................903
└ D0-D7, D8-D15............................................................................................. 903
└ Deskew offset............................................................................................... 903
Threshold setup.......................................................................................................... 903
Enable bus
Enables the selected parallel bus. The corresponding signal icon appears on the signal
bar.
If another active bus already uses the same digital channel, the instrument disables the
other bus and shows a message.
Remote command:
BUS<m>:PARallel:STATe on page 1904
Digital channels and parallel buses