Instrument Function
R&S
®
SMU200A
252Operating Manual 1007.9845.32 ─ 15
Reset Sweep - Frequency Sweep
Resets the sweep. The start frequency is set and the next sweep starts from there.
SCPI command:
[:SOURce<hw>]:SWEep:RESet[:ALL] on page 784
Start Freq - Frequency Sweep
Sets the start frequency.
SCPI command:
[:SOURce<hw>]:FREQuency:STARt on page 718
Stop Freq - Frequency Sweep
Sets the stop frequency.
SCPI command:
[:SOURce<hw>]:FREQuency:STOP on page 719
Center Freq - Frequency Sweep
Sets the center frequency.
SCPI command:
[:SOURce<hw>]:FREQuency:CENTer on page 711
Span - Frequency Sweep
Sets the span.
SCPI command:
[:SOURce<hw>]:FREQuency:SPAN on page 717
Current Freq - Frequency Sweep
Displays the current frequency.
If "Step" is set, the frequency for the next frequency step of the sweep is entered here.
SCPI command:
[:SOURce<hw>]:FREQuency:MANual on page 714
Spacing - Frequency Sweep
Selects linear or logarithmic sweep spacing.
SCPI command:
[:SOURce<hw>]:SWEep[:FREQuency]:SPACing on page 779
Shape - RF Frequency Sweep
Selects the cycle mode for a sweep sequence (shape) .
RF Signal and Analog Modulations - RF Block
To Next Page
Loading...
