Rohde & Schwarz SMU200A - Page 380

Instrument Function
R&S
®
SMU200A
360Operating Manual 1007.9845.32 ─ 15
For more information, see chapter 4.7, "File Management", on page 113.
To ensure that the selected data or control list is used for generating the digital signal,
the list must be selected as the data source:
Data Parameter Selection
Digital data "Source" DList
Marker "Marker Mode" CList
Control signals
CW, Level Attenuation and Burst
Gate
"Source" Internal
The data editor is called using the "Edit Data List..." and "Edit Control List ..." buttons.
The contents of the selected list are displayed.
Operating the list editors is described in chapter 4.5.1, "Working with List Editor",
on page 105.
Select Data/Control List - Digital Modulation
Selects data/control list. This opens the "File Select" window in which the data/control list
can be selected.
SCPI command:
[:SOURce<hw>]:BB:DM:DLISt:SELect on page 652
[:SOURce<hw>]:BB:DM:CLISt:SELect on page 649
Create Data/Control List - Digital Modulation
Creates new data/control list. This opens the "File Select" window in which the data/
control list can be created.
The file name has to be entered in field "File Name:". The new list contains no data, it
can be edited in the list editor.
SCPI command:
[:SOURce<hw>]:BB:DM:DLISt:SELect on page 652
[:SOURce<hw>]:BB:DM:CLISt:SELect on page 649
File Manager - Digital Modulation
Calls the "File Manager".
The File Manager is used to copy, delete and rename files and to create new directories.
SCPI command:
[:SOURce<hw>]:BB:DM:DLISt:SELect on page 652
[:SOURce<hw>]:BB:DM:DLISt:COPY on page 647
[:SOURce<hw>]:BB:DM:DLISt:DELete on page 651
[:SOURce<hw>]:BB:DM:CLISt:SELect on page 649
[:SOURce<hw>]:BB:DM:CLISt:COPY on page 647
[:SOURce<hw>]:BB:DM:CLISt:DELete on page 648
Baseband Signal - Baseband Block