Instrument Function
R&S
®
SMU200A
396Operating Manual 1007.9845.32 ─ 15
"Pattern "
A marker signal that is defined by a bit pattern is generated. The pattern
has a maximum length of 64 bits and is defined in an input field which
opens when "pattern" is selected.
The pattern bits switch the marker signal to high and low state.
SCPI command:
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut<ch>:PATTern on page 593
"ON/OFF
Period"
A regular marker signal that is defined by an ON/OFF ratio is generated.
A period lasts one ON and OFF cycle.
The "ON Time" and "OFF Time" are each expressed as a number of
samples and are set in an input field which opens when ON/OFF ratio is
selected.
SCPI command:
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut<ch>:OFFTime on page 592
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut<ch>:ONTime on page 593
SCPI command:
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut<ch>:MODE on page 592
Marker Delay
The delay of the signals on the MARKER outputs is set in the"Marker Delay" section.
Marker x Delay
Enters the delay between the marker signal at the marker outputs and the start of the
frame or slot.
The input is expressed as a number of symbols. If the setting "Fix marker delay to dynamic
range" is enabled, the setting range is restricted to the dynamic range. In this range the
delay of the marker signals can be set without restarting the marker and signal.
SCPI command:
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut<ch>:DELay on page 586
Current Range without Recalculation
Displays the dynamic range within which the delay of the marker signals can be set with-
out restarting the marker and signal.
The delay can be defined by moving the setting mark.
SCPI command:
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut<ch>:DELay:MINimum on page 587
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut<ch>:DELay:MAXimum on page 587
Baseband Signal - Baseband Block
To Next Page
Loading...
