Operator Manual
6
of 28 SPR2-310.620.30.02.02
Safety
Wear and tear The system is subject to mechanical and electrical wear and tear. In the interest
of the safety of patients, operating personnel and third persons, maintenance and
safety checks must be carried out every 12 months to maintain the operational
safety and reliability of the product.
Please follow the relevant instructions in the
(→ Register 10: Maintenance).
Image quality Maintenance should include checking the image quality. Maintenance at regular
intervals is recommended to always ensure best image quality.
To ensure optimal image quality, have the following functions checked in partic-
ular as part of regular maintenance:
Pixel shift, image rotation, noise reduction, edge enhancement, subtraction,
Roadmapping.
Performing
maintenance
Maintenance work should be performed by trained technical personnel only.
If you do not have a service contract, please contact Siemens Customer Service.
If national laws or regulations specify more frequent checking and/or mainte-
nance, this must be observed.
Caution
Mechanical damage and damage to the system electrics due to improper use
and excessive load on the system.
Injury to operating personnel, patients or third parties and damage to the
product!
â—† If necessary, have the system checked more frequently.
â—† Ensure that any defects are repaired professionally.
To Next Page
Loading...
Need help?
General
