Operator Manual
68
of 98 SPR2-310.620.30.02.02
Documentation
Exporting data 0
Unlike the archiving function, the export function does not check for previous
archiving processes, flags or the work status. In addition, data are not marked as
archived, but only as exported.
General safety information 0
To minimize the risk of data loss, use only CD/DVD-Rs approved by Siemens.
CD/DVD-Rs are available through your Siemens representative.
Never shut down the ARCADIS Varic or disconnect the monitor trolley from the
C-arm system while data is being written to CD/DVD-R.
As a rule, you cannot release radiation during the CD/DVD-R write process.
In exceptional cases (emergencies), you can release radiation in fluoroscopy
mode. However, radiation may be disrupted.
Moreover, the export process of subtracted images to CD/DVD-R is interrupted
during radiation release and other compute-intensive processes (e.g., play LSH).
Images are in those cases stored as raw data.
You are therefore urgently advised to start write processes outside of examina-
tion hours (e.g. at the end of the office day).
Caution
When you read data from a device and simultaneously export data to the same
device, one job or both jobs can fail (depending on the timing).
Loss of data!
â—† When exporting or storing data to a local device (CD, DVD, MOD, DVD-RAM),
do not try to read from the same device in parallel, since this may stop the
current export job and even damage the export medium. If you have stored
data on the export medium in multi-session mode, these data may also
become unreadable.
To Next Page
Loading...
Need help?
General
