Documentation
ARCADIS Varic
SPR2-310.620.30.02.02 11
of 98
Automatic/manual filming 0
The filming and printing of examination images is performed in two steps:
❏ Transfer of images to the virtual film sheet.
❏ Transfer of these images from the virtual film sheet to a camera or printer
where they are exposed on film or printed on paper.
Make sure the printer is switched on before you send images to print.
Configured printers/
cameras
Siemens Service or your system administrator has configured one or several
printers/cameras for your ARCADIS Varic system. At the same time, the names
of output devices that you can choose from selection lists as well as the specified
paper/film size were set up.
Note that you can only print on the paper/film size that was configured for the
respective output device.
Transferring images to the virtual film sheet 0
Images can be transferred for printing from different applications via the control
panel on the C-arm system or at the monitor trolley.
At the C-arm system 0
If a local printer is connected, you can print individual images on paper or X-ray
film directly in the OR.
Initiating local printing
◆ Press the Print key on the control panel of the C-arm system.
– The currently selected image is copied to the virtual film sheet.
– Depending on the setting for exposure on film, the image is transferred
directly to the specified (local) printer and printed there.
To Next Page
Loading...
