Operator Manual
16
of 98 SPR2-310.620.30.02.02
Documentation
Automatic
exposure on
This function may accelerate the workflow associated with evaluation. However,
it is recommended to switch it off prior to the next examination.
â—† Select Options > Auto Expose on the right monitor.
Or
â—† Click the Auto Expose button.
– A film sheet that is completely filled is automatically printed or exposed as
soon as an image for the next (empty) film sheet is transferred.
If the last film sheet is only partially filled, then the configuration settings deter-
mine when it is sent to be filmed.
(→ Page 54)
Automatic
exposure off
â—† Deselect Options > Auto Expose.
Or
â—† Click the active Auto Expose button.
Aborting automatic exposure
If errors occur during automatic filming, or you notice that defective images have
been filmed/printed, you can abort automatic exposure at any time.
â—† Deselect Options > Auto Expose on the right monitor.
â—† Eliminate the fault.
— or —
â—† Delete the faulty images from the virtual film sheet.
â—† Activate Auto Expose again.
— or —
â—† Transfer the remaining sheets to the camera/printer manually.