Operator Manual
22
of 24 SPR2-310.620.30.02.02
Configuration
Activating LUTs
(Look-up-Tables)
â—† In the left column (LUT pool) select the LUT that you want to activate.
â—† Click this button.
– The LUT is moved into the column of active LUTs and is thus available
using the respective keys.
Deactivating LUTs â—† Select the LUT that you want to activate in the right column (LUT pool).
â—† Click this button.
– The LUT is moved to the LUT pool. Thus it is inactive.
Defining the LUT
default settings
The first LUT value in the Active list is set as default. Use the Default buttons to
define a different LUT value as default value.
â—† Select the value you want as default in the right column (active LUTs).
â—† Click this button.
– The default LUT value is displayed in bold on the list.
Saving parameters
â—† Click this button.
– Your changes are applied to the ARCADIS Varic system.
– The configuration dialog remains open for further entries.
â—† Configure further parameters on the corresponding tab card.
—or—
â—† Click this button.
– The dialog box closes.
To Next Page
Loading...
Need help?
General
