Siemens SINAMICS G120 - Page 747

Index
C-747
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Function diagrams Technology controller
Closed-loop control, 2-633
Fixed values, binary selection
(p2216 = 2), 2-630
Fixed values, direct selection (p2216 = 1),
2-631
Motorized potentiometer, 2-632
Function diagrams Technology functions
DC brake (p0300 = 1), 2-628
Function diagrams V/f control
Resonance damping and
slip compensation, 2-584
V/f characteristic and voltage boost,
2-583
Function diagrams V/f control
Vdc_max controller and
Vdc_min controller (V/f control,
PM230/PM240), 2-585
Function diagrams Vector control
Current setpoint filter, 2-597
Current/power/torque limits, 2-596
Display signals, 2-605
Field weakening characteristic, Id setpoint
(ASM, p0300 = 1), 2-600
Field weakening controller
(PEM, p0300 = 2xx), 2-602
Field weakening controller, flux controller
(ASM, p0300 = 1), 2-601
Flux control configuration, 2-594
Id setpoint (PEM, p0300 = 2xx), 2-599
Interface to the Power Module
(ASM, p0300 = 1), 2-603
Interface to the Power Module
(PEM, p0300 = 2xx), 2-604
Iq and Id controllers, 2-598
Kp_n/Tn_n adaption, 2-590
Pre-control balancing, acceleration mod-
el, 2-588
Speed control configuration, 2-593
Speed controller, 2-589
Speed setpoint, droop, 2-587
Torque setpoint, 2-591
Upper/lower torque limit, 2-595
Vdc_max controller and
Vdc_min controller (Vector control,
PM230/PM240), 2-592
G
General
Faults and alarms, 3-654
Function Diagrams, 2-493
Parameters, 1-8
I
IASC, 3-656
Index
Parameters, 1-8, 1-14
Input/Output Terminals
Analog inputs, 2-506
Analog outputs, 2-506
Digital inputs, 2-506
Digital outputs, 2-506
L
List of Abbreviations, B-735
Lists
Abbreviations, B-735
ASCII Table, A-734
Binector Input Parameters, 1-474
Binector Output Parameters, 1-478
Command Data Sets, 1-464
Connector Input Parameters, 1-476
Connector Output Parameters, 1-479
Connector/Binector Output Parameters,
1-483
Drive Data Sets, 1-466
Fault- and Alarm messages, 3-658
List of motor code, A-734
Motor Data Sets, 1-471
Parameters all, 1-16
Power module Data Sets, 1-474
Quick commissioning, 1-485
M
Motorized potentiometer, 2-632
N
Name
Parameters, 1-9
Number
Parameters, 1-8
O
OFF1, 3-656
OFF2, 3-656
OFF3, 3-656