84 Agilent X-Series Signal Generators SCPI Command Reference
Basic Function Commands
Vector Modulation Subsystem—N5172B/82B ([:SOURce]:IQ)
DEDicated Configures the AUX I/O port operating mode to Dedicated for real- time
applications.
MULTiplexed Configures the AUX I/O port operating mode to Multiplexed for real- time
applications.
*RST DED
:AUX:OUTPut:STRobe:SLOPe
Supported N5172B with Option 653 or 655, N5182B with Option 656 or 657
[:SOURce]:IQ:AUX:OUTPut:STRobe:SLOPe POSitive|NEGative
[:SOURce]:IQ:AUX:OUTPut:STRobe:SLOPe?
This command controls the polarity of the AUX output sample clock.
The output sample clock indicates that the signal generator has latched the 16 input data bits. The
signal generator will output this signal in either free- run or external- input- strobe mode. The user
can select the polarity of the output- strobe signal using this command.
POSitive The signal generator will assert a pulse with a rising edge to indicate when it has
latched the 16 input data bits.
NEGative The signal generator will assert a pulse with a falling edge to indicate when it has
latched the 16 input bits. The output pulse will be at least 200 ns wide.
*RST POS
Key Entry Output Strobe Polarity Neg Pos
:OUTPut:IMPairments:AWGN:BANDwidth|BWIDth
Supported N5172B with Option 653 or 655, N5182B with Option 656 or 657
[:SOURce]:IQ:OUTPut:IMPairments:AWGN:BANDwidth|BWIDth <value>
[:SOURce]:IQ:OUTPut:IMPairments:AWGN:BANDwidth|BWIDth?
This command sets the flat noise bandwidth, which is typically set wider than the signal bandwidth.
There will be roll- off of the noise outside of this bandwidth.
*RST 1 Hz
Key Entry Flat Noise Bandwidth
Key Entry Operating Mode Dedicated Multiplexed
Range Option 653: 1 Hz–60 MHz
Option 655: 1 Hz–120 MHz
Option 656: 1 Hz–80 MHz
Option 657: 1 Hz–160 MHz
To Next Page
Loading...
Need help?
General
